#Saitek flight yoke setup pro#
#Saitek flight yoke setup simulator#

HOTAS systems include a flight stick for maneuvering your aircraft and a throttle for controlling your engine(s). Are you looking to simulate flying a real-life Cessna 172? Or are you more interested in arcade style combat games like in Star Wars: Squadrons and Ace Combat 7? Your answer will decide which controller is best for you.ДЇor anyone new to flight simulation, the most popular control system is called a hands-on throttle-and-stick, or HOTAS. The most important thing to consider is your individual need. For a first-time buyer, it can get overwhelming quickly. Like flight simulators, the world of flight controllers is nuanced and complex. With games like Microsoft Flight Simulator, along with Elite Dangerous and Star War: Squadrons, flying a real Boeing 747 or TIE Fighter has never been more fun.Д«ut if you want to feel like a real, skilled pilot, youвЂ™ll need a dedicated flight controller.

#Saitek flight yoke setup simulator#

With the huge launch of Microsoft Flight Simulator in 2020, alongside the grounding of most real world travel, the desire to fly free is stronger than ever. They are not bushed and are likely not useful for mounting.People everywhere are booting up their computers and taking to the skies. Don't get excited about the other holes you see.

#Saitek flight yoke setup pro#

Here is the bottom of the Saitek Cessna Pro Flight Yoke with the holes identified with yellow arrows. I'll post a photo in a few minutes and then others with the Pro Flight can report if that model has the same or similar bushings. The clock/timer mounted on my yoke is about 3 inches in width, so the bushings on the bottom of my yoke about 1 1/2 inches further apart than the edges of the clock/timer. The second set of bushed holes correspond near the back of the yoke. They are set back about 3/4 of an inch from the front edge of the bottom of the yoke. The bushed holes I am speaking about are about 4 1/2 inches apart and straddle the yoke shaft. You would need longer ones to mount the yoke to the desk. You can see four of them at each corner of the multi-panel. The same type knurled threaded fasteners secure the multi-panel's mount to the same type threaded bushings in the top of the yoke. If you look at the photo of my yoke with the Saitek Multi-Panel mounted on top of it (in my earlier post above in this thread) you can see four such knurled knob screws hold the multi-panel to it's mount. If so you may be able to drill matching holes in your desk and use a length of threaded fastener that would reach through into the yoke's bushings, such as a knurled nut. Do not know if the regular Pro Flight Yoke has the same bushings. It has four holes on the bottom with threaded bushings. I have the Saitek Pro Flight Cessna Yoke and just examined it. I seriously doubt that velcro will keep it stable enough to satisfy you, It was not held firm when leverage was applied to the yoke. I have experience with this and a CH yoke that I previously had as it's mounting was small and would not extend far enough back under my desk to secure it. Do you think I could secure the yoke assembly to the top surface of the desk using multiple velcro strips to prevent both forward and lateral movement of the yoke?